Author Topic: AFT destination file rename problem (Read 5436 times)

tbplcntlm · « **on:** August 08, 2012, 10:59:37 AM »

I am using the AFT job type to move a file from source folder to a target folder. I have configured the source file with a wildcard, such as file_*.dat. The destination is defined as /temp/. From the Advanced -> General tab I selected to rename the destination file, such as file.dat. The transfer works successfuly, I can see the file in the detination folder.

The rename does NOT work, getting the following error in Sysout
ftp reply --->450 Requested file action not taken. File unavailable (e.g. file busy).

Any help with this issue is greatly appreciated.

State · « **Reply #1 on:** August 20, 2012, 03:44:05 PM »

I haven't had a chance to play with AFT, but base on the description I would say... a permissions issue? Perhaps?

I would also consider taking you question to the yahoo.com community group control-x. They may have different suggestions as this forum is not yet utilized as it was intended.

byounger · « **Reply #2 on:** November 08, 2012, 12:30:11 PM »

Ran into the same problem when FTP'ing to a 3rd party (bank). Their system was picking up the file immediately so the file was busy or unavailable. To solve I did an AFP to an internal folder with the rename and then FTP'd that renamed file to the 3rd party.

News:

Author Topic: AFT destination file rename problem (Read 5436 times)